How to Build a Smok Pen


How to Build a Smok Pen

The Smok Pen is really a revolutionary vaporizing pen that allows for a write-to-write experience, whilst you are away from home. This is because of the unique design of the pen. It has two tanks, one smaller than the other, that house the e juice and charged batteries. When the user wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.

smok pen

One of the greatest attributes of the Smok Pen is its ability to charge while it is on your own desk. The reason being the coils on the Smok Pen were created in a way to keep the e juice from dripping onto the table or somewhere else. This is due to the 0.3-ohm coil that’s placed inside the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. The reason being the electronic circuitry has protection built-in so that it will not be suffering from extremely low voltage electric currents.

The Smok Pen could be charged internally with a charger or via the USB connection that is included with it. Because the electronic circuitry includes a safety barrier built in, therefore there is no risk involved when charging these devices through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, which is ideal for all pens that use one or two batteries.

In order to keep the Smok Pen doing work for an extended period of time it is important that you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that’s available and may eventually bring about the device malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery isn’t getting the vapor it should, remove the pen from the power source and let it cool off for a few minutes.

The fire button on the Smok Pen is situated at the bottom right corner of these devices. The fire button comes with an orange light, which indicates that it’s on. It is possible to press this button to activate the electronic heating element that may let you vaporize the oil. Once you have done so you can take away the coil from the holder and place it into the holder and place the Smok Pen into the airflow chamber, which will cause the heating element to start heating up and burning away the wick.

When the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they begin to turn blue, that is the indication that it is ready for the pen’s battery. Make sure that you place your sub-ohm into the chamber before you push the fire button. If you do not put the coil in to the airflow chamber then your oil will leak and cause the leaking of e-juice.

Before you put the battery into the pen, you must make sure that you have disconnected all of the leads. Then you need to take out the Smok Pen’s cap and locate the leak Puff Bar Flavors or drip tip. You need to clean this with a little cotton bud, to enable you to eliminate leak. Then reattach the cap back to the Smok Pen and you are ready to place the battery in to the pen.

The ultimate part of the construction process may be the adapter plate, which fits in to the Smok Vaporizer’s USB port. This plate enables you to charge your e-juice during your computer, as long as you have an adapter for USB connection. I like this part since it allows me to charge my entire kit at once without fretting about running out of power or constantly running out of e-juice.